Important D-Link DIR 850L Firmware update – Standard
Customers using the DLINK DIR-850L router are urged to perform a firmware update to address a security vulnerability. For customers who have purchased this modem from Skymesh, we sent you an email linking to these instructions.
1: Download the new firmware
Please note the firmware contains two separate files.
2: Connect to LAN
Please ensure your computer is plugged into one of the black ports on your router.
3: Apply the update
Click apply update below to continue.
Enter your admin username (‘admin’) and your admin password.
Click on the ‘Management’ heading in the top-right corner of the screen. Select ‘Upgrade’ from the drop-down menu.
Click the ‘Select File’ button.
Select the first file (‘FW210WWb03.bin’) and click ‘Upload’. This file will most likely be in your ‘Downloads’ folder.
Select the second file (‘FW220WWb03.bin’) and click ‘Upload’. This file will most likely be in your ‘Downloads’ folder.
After both firmware upgrades have been installed, we recommend connecting your computer to the LAN 1 port of the DIR-850L with an Ethernet cable. This will mean that you will still be able to access your router after performing a factory reset.
4: Complete a factory reset
1. Leave your modem router powered on. Using a paperclip or something sharp press the reset button on the bottom of the unit and hold it for 10-15 seconds.
2. Release the reset button and allow your router 2-3 minutes to reboot after a factory reset. Once the reset is complete your power light should return to a solid green state.
5: Set up your router
Click below to start setting up your router.
You may see a setup wizard. Click the ‘Cancel’ button to be taken to the main menu for your router.
Click on the heading marked ‘Settings’ at the top of the page. Select ‘Internet’ from the drop-down menu.
Click on the drop-down menu marked ‘My Internet Connection’. Set this to ‘Dynamic IP’.
Click the ‘save’ button at the top of this page to save your settings.
6: Setting up your D-Link DIR-850L WiFi networks and admin password
Click on the heading marked “Settings” at the top of the page. Select “Wireless” from the dropdown menu.
Your wireless settings should be as follows:
2.4GHz
– Status: Enabled
– Wi-Fi Name (SSID): The network name that you noted earlier.
– Password: The WiFi password that you noted earlier.
5GHz
– Status: Enabled
– Wi-Fi Name (SSID): The network name that you noted earlier.
– Password: The WiFi password that you noted earlier.
Click on the ‘Save’ button at the top of the page.
Click on the ‘Management’ heading at the top of the page and select ‘System Admin’ from the drop-down menu.
Type the admin password that you used previously and click save
